2014 Volkswagen CC

Issue: 
On certain vehicles, the ESC warning light may not remain on if a fault was detected on the previous key cycle. Instead, the warning light does not turn on until the vehicle starts to move. Canadian regulations require that the ESC warning light must turn on when the vehicle is started (under these conditions).
Note: This problem can only happen if there is a fault related to the power steering system. The power steering warning light would stay on to advise that there is a fault with the steering system.

Safety Risk: 
This small error does not affect vehicle safety. 
 
Corrective Actions: 
This is not a recall. The company has made changes to the vehicle software to correct this issue on all new vehicles.

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the driver frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the driver frontal airbag inflator. Note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected. Additional Note: This recall supersedes the Volkswagen brand vehicles subject to recall 2016-064 (Volkswagen Recall 69M9). Volkswagen vehicles completed under the previous 2016-064 recall require repair under this recall, as the previous recall remedy was an interim repair. Interim repair parts must be replaced with final repair parts.

On certain vehicles, there could be an interruption in electrical power to the fuel pump control module. This could result in the fuel pump running continuously, resulting in a drained battery and/or a no start condition, or cause a loss of motive power while the vehicle is in motion, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the fuel pump control module and relocate it within the vehicle.

On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the front driver airbag inflator. Note: This campaign only affects the Audi A5 and Audi S5 Cabriolet models.

On certain vehicles, the steering wheel clock spring could become contaminated with long hair or long fibers which may cause a displacement of the internal guide loops.  When the guide loops are dragged out of position, they may apply tension to the internal flat cable and cause it to tear.  Should the cable tear, the electrical connection to the driver's front airbag may be lost, causing the airbag monitoring indicator light to illuminate.  Failure of the driver's airbag to deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant.  Correction: Dealers will install a cover of a different design to help prevent clock spring contamination caused by hair or other fibers. In instances where the vehicle has an airbag light on (and diagnosis confirms the steering wheel clock spring requires replacement), dealers will install a new steering wheel clock spring.