2004 Mazda Tribute

On certain vehicles registered and operated in areas where road salt is used on the roadways during winter months for extended time periods (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland-Labrador), the forward attachment point for the lower control arm may separate from the vehicle's subframe. This could affect vehicle handling and increase the risk of a crash causing injury and/or property damage. Correction: Dealers will install a newly designed reinforcement cross-brace.  Note: this is an expansion of recall 2014-117.

On certain vehicles registered and operated in areas where road salt is used on the roadways during winter months for extended time periods (Ontario,
Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland-Labrador), the forward attachment point for the lower control arm may separate from the vehicle's subframe. This could affect vehicle handling and increase the risk of a crash causing injury and/or property damage. Correction: Dealers will install a newly designed reinforcement cross-brace.

On certain vehicles equipped with a 3.0L V6 engine and speed control, inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed.  A stuck throttle may result in very high vehicle speeds and make it difficult to slow or stop the vehicle if the transmission is not shifted into neutral.  This could result in a crash causing property damage and/or personal injury.  Correction: Dealers will replace the rear engine cover fastener, which will raise the cover in the area of the speed control cable to provide adequate clearance between the cover the speed control cable connector.

On certain vehicles, the electrical wiring connector to the ABS module may have been manufactured incorrectly.  Over time, contaminants can enter the ABS electrical connector interface and corrode the terminals.  This could cause the ABS warning indicator to illuminate, an open fuse, and in some instances, smoking, melting or burning of the electrical connector, with the potential for a fire while the vehicle is unattended.  In addition, ABS function may be lost.  Correction: Dealers will inspect and, if required, repair the wiring connector.

Certain vehicles do not comply with the requirements of CMVSS 206 - Door Locks and Door Retention Components.  The rear liftgate latching system does not meet the Technical Standards Document 206 Inertia Load requirement.  If the liftgate is left unlocked, it may open during a severe collision.  Correction: Dealers will replace the rear liftgate latch release rod and attachment clip.