2008 Toyota Yaris

Issue: 
This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. 

On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. 

Note: This recall only affects the following block heater/cord part numbers: 

C014003034                         PK5A408J09                         PU14000904 
C014003151                         PK5A408J13                         PU14000905 
C014000885                         PK5A489J11                         PU14000907 
C014000888                         PK5A489J22                         PU14000909 
C014000907                         PK5A410H00                        PU14000911 
C014100904                         PU14000900                         PU14000913 
C014100907                         PU14000901                         PU14003571 
C014100911                         PU14000902                         PK5A489J14 
PK5A408J05                        PU14000903 

Safety Risk: 
Engine block heater wiring that overheats or melts could create the risk of a fire. 

Corrective Actions: 
Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Depending on the model, dealers will either replace the passenger frontal airbag inflator or airbag assembly. Note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected.

On certain vehicles, the front seat position adjustment mechanism springs could break, which could cause the seat to appear to be locked into position even though it is not. This could allow the seat to slide forward or rearward in a crash, increasing the risk of injury and/or damage to property. Correction: Dealers will inspect seat rails and replace as necessary.

On certain vehicles, electrical circuitry in the steering wheel assembly may become damaged.  As a result, the driver's airbag may not function as intended, causing the instrument panel airbag warning lamp to illuminate.  Failure of the driver's airbag to deploy during a crash (where deployment is warranted) could increase the risk of injury to the seat occupant.  Correction: Dealers will replace the spiral cable assembly.

On certain vehicles, due to improperly applied grease, the driver's side power window master switch could stick or become inoperative. If attempts are made to lubricate the switch, the switch assembly could overheat and melt. A melting switch may produce smoke and potentially lead to a fire causing property damage and/or personal injury. Correction: Dealers will inspect the driver's power window master switch and apply a specialized grease that inhibits heat build-up, or replace the power window master switch circuit board, as necessary.