On certain vehicles, the nuts which secure the pinion shaft inside the steering gear box may not have received adequate tightening torque during the assembly process. If the steering wheel is repeatedly and strongly turned to the full-lock position, the nuts could loosen, allowing the pinion shaft to become unstable. This could cause a loss of steering power assist when making a left turn, which may result in a crash causing property damage and/or personal injury. Correction: Dealers will replace both pinion shaft nuts with improved versions.
On certain vehicles, improper manufacturing of the Crankshaft Position Sensor body could cause engine oil to penetrate the seal and enter the sensor wiring connector. In addition, the wire harness connector may not be sufficiently attached to the locking tab of the sensor wiring connector. Engine oil inside the sensor wiring connector could cause expansion due to the heat of the engine and could deform the sensor wiring connector. In the worst case, the connector may become disconnected, which could cause the engine to stall while driving and not be able to be restarted. Correction: Dealers will replace the Crankshaft Position Sensor.
On certain vehicles, insufficient electrical contact may occur in the torque sensor which controls the power assist operation of the electric power steering gear box. This could possibly cause the power steering warning icon to be displayed and the driver would experience higher than normal steering effort. Correction: Vehicles will be inspected and, if necessary, electric steering box will be replaced.