2007 Pontiac Vibe

Issue: 
On certain cars, the passenger-front airbag that was installed during prior recall repair must be replaced. The airbag may not unfold properly when it deploys. This could cause the airbag to tear or not inflate properly in a crash.
 
Safety Risk: 
An airbag that does not work properly could create an increased risk of injury in a crash.
 
Corrective Actions: 
General Motors will notify owners by mail and instruct them to take their vehicle to a dealer to replace the passenger-front airbag assembly.

On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the passenger frontal airbag module.<br><br>

Note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected. Vehicles may have had the original front passenger airbag module replaced as a "like-for-like" replacement under recall 2015-272 (GM Recall #14491) as a temporary remedy while evaluating a permanent remedy. These vehicles will receive the permanent remedy passenger airbag assembly under this recall.

On certain vehicles, the passenger (frontal) airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the passenger airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Note: This recall supersedes recalls 2013-116, 2014-301 and 2015-272.  Correction: Dealers are to replace the front passenger airbag assembly with one equipped with a newly specified inflator.

On certain vehicles, the passenger (frontal) airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the passenger airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant.  Note: This recall is superseded by recall 2016106. Please see recall 2016106 for more information.  

<a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2016106">Click here for more information</a>

On certain vehicles equipped with a 1.8L MFI engine and a two-wheel drive transmission, the Engine Control Module (ECM) may have been improperly manufactured.  There is a possibility that a crack may develop at certain solder points or on varistors on the circuit board.  In most cases, if a crack occurs at certain points or on certain varistors, the engine warning lamp could be illuminated, harsh shifting could result, or the engine may not start.  In some instances, if cracking occurs on particular solder points or varistors, the engine could stop while the vehicle is being driven, increasing the risk of a crash causing personal injury.  Correction: Dealers will inspect and, if necessary, replace the ECM.