2000 Oldsmobile Silhouette

On certain vehicles equipped with second-row bucket seats or captain's chairs and power sliding door on the passenger side, if a passenger uses the interior handle to open the power sliding door and holds onto the handle while it is being opened by the motor, the passenger's arm may be pushed into the seat back or armrest and a wrist or lower arm injury may result.  Correction:  Dealers will replace the original interior power sliding door handle.  The original handles are offset from the door panel and a passenger can wrap his or her fingers around them.  The replacement door handles are essentially flush with the door trim, preventing a passenger from gripping them in the same fashion.

Certain 1997-2001 Chevrolet Venture, Pontiac Montana/ Trans Sport, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from April to August 2001. Also 2001 Chevrolet Venture, Pontiac Montana, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors assembled in January through April 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator can jam in the unlatched position and, when the sliding door closes, it will not be latched. If this happens, the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the van and be injured.  Correction: dealers will inspect the actuators for certain date codes and, if necessary, replace the actuators.

Certain vehicles may exhibit a condition in which the power sliding door closes, but is not latched, If this happens the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface.  An unrestrained occupant could fall out of the vehicle and be injured.  Correction:  Dealers will install a new power sliding door un-latch actuator assembly.

Certain vehicles do not comply with the requirements of C.M.V.S.S. 209 - Seat Belt Assemblies.  Vehicles may have seat belt assemblies that will not withstand the force requirements of the standard.  In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant.  Correction:  Suspect buckle assemblies will be replaced.

Certain vehicles do not comply with the requirements of CMVSS 301 - Fuel System Integrity.  Vehicles have inoperative fuel tank rollover valves and fuel leakage could exceed the permissible amount in a rollover.  In the presence of an ignition source, a fire could occur.  Correction:  Fuel tanks with inoperative rollover valves will be replaced.